1. Forum
  3. Roboteq Motor Controllers
  5. Troubleshooting
  7. Motor creep

Motor creep

14 years 8 months ago #29073295 by Darrell
Motor creep was created by Darrell
After shutting off the R/C transmitter, the drive motors begin to slowly creep forward. Any idea how to stop this other than my kill switch on the Roboteq?<br>

Please Log in or Create an account to join the conversation.

14 years 8 months ago #29080413 by cosma
Replied by cosma on topic Re:Motor creep
If the controller is an AX2550 or AX3500, the LED display should be flashing the letters "no ctrl" when no radio signal is present.

If not, this would mean that the radio is picking up noise that is falsely interpreted as a valid signal.

Please Log in or Create an account to join the conversation.

14 years 8 months ago #29084010 by Darrell
Replied by Darrell on topic Re:Motor creep
It is a 2550. Thanks Cosma, I'll check that.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Troubleshooting
  7. Motor creep
Time to create page: 0.073 seconds