inversing analog joystick
13 years 11 months ago #29525053
by roboteq
inversing analog joystick was created by roboteq
We have the AX2550HE 2-2-3 v1.9f.
and an analog joystick.
Is there a way to configure the controller so that I can inverse just the y-axis (or say, just channel 2) for use in Analog mode?
Roborun of course will do it in rs-232 mode, but I was assuming those configurations would effect Analog mode as well, and they just aren\'t. And I can\'t find a command for that.
and an analog joystick.
Is there a way to configure the controller so that I can inverse just the y-axis (or say, just channel 2) for use in Analog mode?
Roborun of course will do it in rs-232 mode, but I was assuming those configurations would effect Analog mode as well, and they just aren\'t. And I can\'t find a command for that.
Please Log in or Create an account to join the conversation.
- cosma
13 years 11 months ago #29525054
by cosma
Replied by cosma on topic Re:inversing analog joystick
The controller can\'t invert the analog input.
If you have access to the pot that is insie the joystick, you can swap the ground and 5V terminal on it.
If you have access to the pot that is insie the joystick, you can swap the ground and 5V terminal on it.
Please Log in or Create an account to join the conversation.
13 years 11 months ago #29525058
by roboteq
Replied by roboteq on topic Re:inversing analog joystick
Thanks. The idea was to have the y-axis joystick be easily invertible for operator preference. We\'ll just have to make it connect via rs-232 and have laptop on board, which is a little annoying, but oh well.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.076 seconds
