motors running very slow?

11 years 1 month ago #29525105 by fatal-exception
motors running very slow? was created by fatal-exception
Hi. I bought an AX1500 and have been using it for about a couple of evenings now. It\'s been working fine until last night. Now it\'s only running the motors at about 1/4 of what it should be.

This is true for both computer contol and RC modes.

Any suggestions?

Thanks,
Paul

Please Log in or Create an account to join the conversation.

11 years 1 month ago #29525106 by cosma
Replied by cosma on topic Re:motors running very slow?
Make sure the power output gain is at 100% (in the Power tab).

Try reloading the firmware. Use the latest version if not already install.

The firmware never goes bad but updating will cause to reload all factory defauts.

Use roborun for troubleshooting. Verify that you have good voltages measured. Internal voltage is the most critical and must be over 11V.

Check that the power out on the chart follows the command value.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.106 seconds