SDC2130 - analog input not working

11 years 5 months ago #29525679 by NIdavid
Problem: analog input does not drive the motor

I am having difficulty in using the analog inputs of the SDC2130 motor controller to run a motor.

I have set the priority to analog and the analog input in Roborun+ gives the correct voltage reading but the motor does not receive power.

I do not know if this is relevant but under the status section of the run tab in Roborun+ the serial light is on even though serial has been disabled. I can drive the motor using serial.

Any help is appreciated.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.074 seconds