R/C Auto Center not working with AX2550

8 years 11 months ago #29526093 by wstuck
I am using an AX2550 in R/C input mode with A and B position mode. The feedback pots are setup for each motor. The motors move FWD or Reverse with the R/C controller as expected but when I let off the R/C joystick the motors don\'t move back to the center position to match the current joystick position.

Any Suggestions?

Thanks for your help.

Please Log in or Create an account to join the conversation.

8 years 11 months ago #29526095 by wstuck
FYI – I found the problem.

When I changed from an analog input to the R/C input I did not change the feedback signals from Analog #3 and #4 to Analog #1 and #2. I also missed adding the +5V wire needed to power the feedback pots when I changed the 15 pin connector.

The system is working fine now that I have it wired correctly.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.146 seconds