No voltage on Output C

9 years 5 months ago #29526515 by Anonymous
No voltage on Output C was created by Anonymous
I'm using an AX1500 with DC motors and was planning on using output C (Pin 1/9) to release the breaks on the motor. I am using the Roboteq controller configuration utility(V.1.9f) and I have checked "Out C ON when Motors Active" I'm using RC Radio as the controller Input. But after extensive testing, I do not get a voltage out on Pin 1 or 9 even when there is a voltage to the motor. I would appreciate any help with this problem.

Please Log in or Create an account to join the conversation.

9 years 5 months ago #29526516 by Roboteq
Replied by Roboteq on topic RE: No voltage on Output C
The output will pull to ground when on. So it is normal that you would measure zero. You need the load to be connected between the output and a positive voltage. See the manual which can be obtained at www.roboteq.com

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.742 seconds