1. Forum
  3. Roboteq Motor Controllers
  5. Troubleshooting
  7. Can't set up parameters using switches

Can't set up parameters using switches

12 years 7 months ago #29526723 by Anonymous
Can't set up parameters using switches was created by Anonymous
AX-2550 Series I-1010 Build 1005 PCB 9.1 Software revision based on 7-seg display is 1-9 followed by unrecognizable characters. The main problem is that in setting up the parameters by means of the program and set switches, the sequence of parameters skips parameter "U". Consequently, I cannot enable input 15 for emergency stop. Please advise action to resolve.

Please Log in or Create an account to join the conversation.

12 years 7 months ago #29526724 by Roboteq
Replied by Roboteq on topic RE: Can't set up parameters using switches
Use the pc utility to configure the controller. Some features can no longer be configured with the switches.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Troubleshooting
  7. Can't set up parameters using switches
Time to create page: 0.053 seconds