VBL2360 U-phase dead?
7 years 4 months ago #29528630
by johgum
VBL2360 U-phase dead? was created by johgum
I have just started to test my new VBL2360 controller and I think there is someting wrong with it. I suspect that the U-phase is dead on both channels.
I have confirmed that the hall sensor sequence is correct by putting an Arduino between the hall sensors and the controller. Also, the hall counter in Roborun+ counts booth up and down perfectly.
HallA 1 1 0 0 0 1
HallB 0 1 1 1 0 0
HallC 0 0 0 1 1 1
By applying a small amount of power to the motor I get the following output, following the sequence above:
U 0 0 0 0 0 0
V 0 + 0 0 - 0
W 0 - 0 0 + 0
With some help, the motor starts spinning but not very smooth since it's only driving on two out of six output sequences.
I have tried my hub mo
tor with an old ebike controller and it spins nicely in both directions.
Have I missed something or is the U-phase dead? Are there other ways of testing?
I have confirmed that the hall sensor sequence is correct by putting an Arduino between the hall sensors and the controller. Also, the hall counter in Roborun+ counts booth up and down perfectly.
HallA 1 1 0 0 0 1
HallB 0 1 1 1 0 0
HallC 0 0 0 1 1 1
By applying a small amount of power to the motor I get the following output, following the sequence above:
U 0 0 0 0 0 0
V 0 + 0 0 - 0
W 0 - 0 0 + 0
With some help, the motor starts spinning but not very smooth since it's only driving on two out of six output sequences.
I have tried my hub mo
Have I missed something or is the U-phase dead? Are there other ways of testing?
Please Log in or Create an account to join the conversation.
- Griffin Baker
7 years 4 months ago #29528631
by Griffin Baker
Replied by Griffin Baker on topic VBL2360 U-phase dead?
Have you tried switching the U wire on each motor?
Channel 1 UVW is White, Green, Blue.
Channel 2 UVW is Brown, Orange, Purple.
Channel 1 UVW is White, Green, Blue.
Channel 2 UVW is Brown, Orange, Purple.
Please Log in or Create an account to join the conversation.
7 years 4 months ago #29528634
by johgum
Replied by johgum on topic VBL2360 U-phase dead?
Stupid misstake. Didn't do my homework.
Thanx
Thanx
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.084 seconds