MBL1330N giving fluctuation in motor current.
- ateequeFox
- Topic Author
- Offline
8 years 3 months ago #29530235
by ateequeFox
MBL1330N giving fluctuation in motor current. was created by ateequeFox
I had recently purchased 3 numbers of MBL 1330N controllers, out of which two are working fine and one is giving some problems. when i connect the motor and run it from Run Tab in roborun+, it is giving motor current fluctuation while running in both directions. I had tried with another controller on the same motor, its fine and motor current is stable.
Please provide a solution for the above problem as i am in last stage of my project.
I am attaching the log file for the same.
Please provide a solution for the above problem as i am in last stage of my project.
I am attaching the log file for the same.
Please Log in or Create an account to join the conversation.
8 years 3 months ago - 8 years 3 months ago #29530236
by TechSupport
Replied by TechSupport on topic MBL1330N giving fluctuation in motor current.
Please verify what the firmware is on all 3 controllers. I want to make sure that the firmware difference is not the cause of the problem you are facing.
Please Log in or Create an account to join the conversation.
- ateequeFox
- Topic Author
- Offline
8 years 3 months ago #29530240
by ateequeFox
Replied by ateequeFox on topic MBL1330N giving fluctuation in motor current.
All three controllers are having the latest firmware version 11/21/14 1.4a. So I think the firmware is not the problem. Kindly suggest solution for the above problem.
Please Log in or Create an account to join the conversation.
8 years 3 months ago #29530250
by TechSupport
Replied by TechSupport on topic MBL1330N giving fluctuation in motor current.
Please request for an RMA via This email address is being protected from spambots. You need JavaScript enabled to view it.
If controller was purchased in the last 90 days it is covered under warranty.
If controller was purchased in the last 90 days it is covered under warranty.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.060 seconds
