MDC2230 V3.2 Analog inputs

When i activate AIn1 or AIn2 they read a value of about 2500 without anything connected to them. When i connect them to ground they read about 1350. It doesn't matter if they are set to Absolute or Relative.

AIn3 and AIn4 do read the actual voltage.

I tested 5 MDC2230 V3.2 they all do the same.
I never had this problem with te V2.1

What might go wrong here?

You must go in the Pulse 1 and Pulse 2 configuration, and disable pulse capture.

On the new MDC2xxx, when pulse capture is enabled, a weak pull up is added to the input in order to make pulse capture work more reliably with RC radios with 3V pulse signal.

That solves it for AIn2.

AIn1 now fluctuates between 50 and 100 and doesn't seem to react to any input.

The Roborun+ only shows AIn1 to AIn4 where AIn4 reacts to pin 11(ANA5). I switched on AIn5 with the console, witch reacts on pin 10(ANA4). Is there a new version of the software where i can configure AIn5 through the configuration tab?