1. Forum
  3. Roboteq Motor Controllers
  5. Troubleshooting
  7. MBL1330 does not driver motor when connected via USB to RoboRun+

MBL1330 does not driver motor when connected via USB to RoboRun+

6 years 4 months ago #29532608 by vagrantzombie
MBL1330 does not driver motor when connected via USB to RoboRun+ was created by vagrantzombie
One of my service engineers is trying to gather data from MBL1330 to diagnose an issue (motor only runs one direction). However, he says he cannot drive the motor while connected to the driver with RoboRun+. Is there something that could be preventing motion under this condition? I have not seen this in my experience.

Please Log in or Create an account to join the conversation.

6 years 4 months ago #29532609 by blake
Replied by blake on topic MBL1330 does not driver motor when connected via USB to RoboRun+
If the MBL1330 drives the motor in one direction but not the other it is possible that the phase wiring (UVW) is out of order. Another possibility is a damaged MOSFETs. Was this particular controller driving the motor well in both directions previously and stopped driving in both directions at some point during operation. Or did it only drive the motor in one direction from the first hookup?

Please Log in or Create an account to join the conversation.

6 years 4 months ago #29532612 by vagrantzombie
Replied by vagrantzombie on topic MBL1330 does not driver motor when connected via USB to RoboRun+
Hi Blake, thanks for your response. The engineer is trying to connect PC to MBL1330, to monitor hall counter and motor amps (to try to diagnose if phase wiring is out of order, by ensuring hall counter and motor amperage increases smooth and steady for both forward and reverse). However, he is unable to run the motor when on the RUN tab in the RoboRun program. He can only run the program while on the Configuration screen (so he cannot monitor data in real time).

Please Log in or Create an account to join the conversation.

6 years 4 months ago #29532613 by blake
Replied by blake on topic MBL1330 does not driver motor when connected via USB to RoboRun+
Please download and install TeamViewer and then contact me at This email address is being protected from spambots. You need JavaScript enabled to view it. so that we can take a look at this together

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Troubleshooting
  7. MBL1330 does not driver motor when connected via USB to RoboRun+
Time to create page: 0.063 seconds