1. Forum
  3. Roboteq Motor Controllers
  5. Troubleshooting
  7. Magnetic Guide Sensors_Continuous disconnecting via serial communication

Magnetic Guide Sensors_Continuous disconnecting via serial communication

5 years 10 months ago #29533040 by Gunasekara
Magnetic Guide Sensors_Continuous disconnecting via serial communication was created by Gunasekara
Hi
wrote a code for the sensor and uploaded to it.After that it doesn't connect to the PC.
Is there way to reset(erase) the code that i uploaded.

code-

dim select_right as boolean
top:
setcommand(_DSET,TV)
setcommand(_DRES,TX)
goto top

thank you

Please Log in or Create an account to join the conversation.

5 years 10 months ago #29533041 by roboteq
Replied by roboteq on topic Magnetic Guide Sensors_Continuous disconnecting via serial communication
you need to connect to the PC with serial port. Then select the com port manually on the utility. Then keep pressing on the pause script button.

Please Log in or Create an account to join the conversation.

5 years 10 months ago - 5 years 10 months ago #29533048 by Gunasekara
Replied by Gunasekara on topic Magnetic Guide Sensors_Continuous disconnecting via serial communication
I mentioned about the magSensor control utility .It does not include the pause button.
Thank you.
Attachments:

Please Log in or Create an account to join the conversation.

5 years 10 months ago #29533058 by blake
Replied by blake on topic Magnetic Guide Sensors_Continuous disconnecting via serial communication
It will be the Stop button:

Attachments:

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Troubleshooting
  7. Magnetic Guide Sensors_Continuous disconnecting via serial communication
Time to create page: 0.056 seconds