Cross talk between different motor channels
- davidezilio
- Topic Author
- Offline
Less
More
- Posts: 2
- Thank you received: 0
5 years 6 months ago #29533512
by davidezilio
Cross talk between different motor channels was created by davidezilio
Hi
I am using 2 RoboteQ SDC2130 motor controllers.
Each one is attached to 2 different motors.
I tried running the motors by
- sending serial commands with Roborun+
- through an Arduino script
In both scenarios I have the following erroneous behaviour:
The commands sent to the first motor being exercised are executed correctly.
After that, the commands sent to the second motor are not executed correctly and both motors start to spin as if there was some cross talk or queuing issues.
I have added delays but this did not solve the issues.
I am attaching the Arduino script for reference
Thanks in advance
Davide
I am using 2 RoboteQ SDC2130 motor controllers.
Each one is attached to 2 different motors.
I tried running the motors by
- sending serial commands with Roborun+
- through an Arduino script
In both scenarios I have the following erroneous behaviour:
The commands sent to the first motor being exercised are executed correctly.
After that, the commands sent to the second motor are not executed correctly and both motors start to spin as if there was some cross talk or queuing issues.
I have added delays but this did not solve the issues.
I am attaching the Arduino script for reference
Thanks in advance
Davide
Please Log in or Create an account to join the conversation.
- Gabriel_Isko
5 years 6 months ago #29533515
by Gabriel_Isko
Replied by Gabriel_Isko on topic Cross talk between different motor channels
Do you think you can post your configuration? It sounds like the motors are behaving in mixed steering mode.
Please Log in or Create an account to join the conversation.
- davidezilio
- Topic Author
- Offline
Less
More
- Posts: 2
- Thank you received: 0
5 years 6 months ago #29533517
by davidezilio
Replied by davidezilio on topic Cross talk between different motor channels
I found the solution thanks to this
www.roboteq.com/index.php/forum/14-gener...28838-sdc2130-issues
In practice I had to disable the watchdog.
www.roboteq.com/index.php/forum/14-gener...28838-sdc2130-issues
In practice I had to disable the watchdog.
Please Log in or Create an account to join the conversation.
- Gabriel_Isko
5 years 6 months ago #29533518
by Gabriel_Isko
Replied by Gabriel_Isko on topic Cross talk between different motor channels
Okay, glad to hear you found the issue.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.064 seconds