Motor doesn't react while on "RUN" tab in Robrun
3 years 1 month ago #29535109
by Rafau
Motor doesn't react while on "RUN" tab in Robrun was created by Rafau
Hello,
I have problem with my drivers SDC2160. When i try to check inputs in RUN tab in Roborun software, motor sudenly stops and don't react to any signals. Because of this I cannot diagnose them in runtime. I'm connecting my PC via USB directly to drivers. I remeber that this issu didn't occur on SDC2130.
Can anyone help me with this issue? What am i doing wrong ?
Best regards
Rafal Kucharski
I have problem with my drivers SDC2160. When i try to check inputs in RUN tab in Roborun software, motor sudenly stops and don't react to any signals. Because of this I cannot diagnose them in runtime. I'm connecting my PC via USB directly to drivers. I remeber that this issu didn't occur on SDC2130.
Can anyone help me with this issue? What am i doing wrong ?
Best regards
Rafal Kucharski
Please Log in or Create an account to join the conversation.
3 years 1 month ago - 3 years 1 month ago #29535111
by Rafau
Replied by Rafau on topic Motor doesn't react while on "RUN" tab in Robrun
Is support team even active on this site ? Nobody knows anything about similar problem?
EDIT: It was silly mistake. There were wrong signals piorities set in driver configuration. Clicking MUTE near sliders on RUN tab in Roborun software solved the problem.
EDIT: It was silly mistake. There were wrong signals piorities set in driver configuration. Clicking MUTE near sliders on RUN tab in Roborun software solved the problem.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.073 seconds