- Forum
- Roboteq Motor Controllers
- Troubleshooting
- FBL2360 connected to MGS1600Y unable to detect left and right marker signals
FBL2360 connected to MGS1600Y unable to detect left and right marker signals
2 years 10 months ago #29535261
by shirofizz
FBL2360 connected to MGS1600Y unable to detect left and right marker signals was created by shirofizz
Hello folks,
I'm using newly purchased FBL2360TE motor controller which is connected to MGS1600Y to make a AGV using MultiPWM connections. It can read Magsensor track detect(_MGD) and read Magsensor track position(_MGT) but it cannot read Magsensor markers(_MGM) on Roborun+ Utility. On Tracksensor utility however, left and right marker signals can be detected without any problems under the "status" box.
For the connections, Pin 15 of MGS1600Y is connected to Pin 24 of FBL2360TE which is pin 7 as pulse input.
I'm using newly purchased FBL2360TE motor controller which is connected to MGS1600Y to make a AGV using MultiPWM connections. It can read Magsensor track detect(_MGD) and read Magsensor track position(_MGT) but it cannot read Magsensor markers(_MGM) on Roborun+ Utility. On Tracksensor utility however, left and right marker signals can be detected without any problems under the "status" box.
For the connections, Pin 15 of MGS1600Y is connected to Pin 24 of FBL2360TE which is pin 7 as pulse input.
Please Log in or Create an account to join the conversation.
Less
More
- Posts: 49
- Thank you received: 4
2 years 10 months ago #29535262
by Athanasios
Replied by Athanasios on topic FBL2360 connected to MGS1600Y unable to detect left and right marker signals
Hi Shirofizz,
what is the firmware in the FBL2360 and what is the firmware in the MGS1600Y.
You may need a firmware update if you use V2.01 with FBL,
If so please send an email This email address is being protected from spambots. You need JavaScript enabled to view it. and This email address is being protected from spambots. You need JavaScript enabled to view it.
what is the firmware in the FBL2360 and what is the firmware in the MGS1600Y.
You may need a firmware update if you use V2.01 with FBL,
If so please send an email This email address is being protected from spambots. You need JavaScript enabled to view it. and This email address is being protected from spambots. You need JavaScript enabled to view it.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
- Forum
- Roboteq Motor Controllers
- Troubleshooting
- FBL2360 connected to MGS1600Y unable to detect left and right marker signals
Time to create page: 0.060 seconds