I managed to get the strip.ocx registered-- but now I get a serious \"stop\" error in Windows whenever I run the Roborun program. Specifically, I run the program, and have to select a Com Port to find the ax1500 motor controller. All com ports from 1 through 7 are empty, but when I choose Com Port 8 I get the \"stop\" error in Windows, and the \"blue screen\" warning that this is a serious error. It also advises that the error is likely caused by the installation of new drivers or software (I assume the \"strip.ocx\" file is the culprit), and the driver or software should be removed to prevent further potential system damage.
Any Help will be greatly appreciated!
Thanks