- Forum
- Roboteq Motor Controllers
- Desired Features & Suggestions
- Feature Request: CAN 2.0B in Raw CAN mode (29bit identifiers)
Feature Request: CAN 2.0B in Raw CAN mode (29bit identifiers)
4 years 4 months ago #29534520
by scdwyer
As far as I can tell, the CAN support is limited to 11bit identifiers. It would be awesome to get 29bit identifier support so it would be easier to integrate with buses with the extended identifier. Specifically, for integration with J1939/NMEA2000/ISO11783 networks.
Is there any chance of this feature in the near future or that I have missed the documentation for it?
Is there any chance of this feature in the near future or that I have missed the documentation for it?
Please Log in or Create an account to join the conversation.
- Gabriel_Isko
4 years 4 months ago #29534522
by Gabriel_Isko
Replied by Gabriel_Isko on topic Feature Request: CAN 2.0B in Raw CAN mode (29bit identifiers)
We have no current plans to implement 29 bit identifiers.
Please Log in or Create an account to join the conversation.
4 years 4 months ago #29534523
by scdwyer
Replied by scdwyer on topic Feature Request: CAN 2.0B in Raw CAN mode (29bit identifiers)
Thank you for the feedback. Not the answer I was hoping for, but good to know!
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
- Forum
- Roboteq Motor Controllers
- Desired Features & Suggestions
- Feature Request: CAN 2.0B in Raw CAN mode (29bit identifiers)
Time to create page: 0.057 seconds