jJoystick Interface

13 years 11 months ago #13377922 by hemantdandekar

Sir We have interface joystick to the Robotekq on pin 10 and 11 and taken a +5 volt from pin 14 and ground from pin 13 for joystick and running the controller in Analog mode. It works fine but the speed we are getting on the motor are very slow. Why? Can Joystick be used in Position mode as well?

Please Log in or Create an account to join the conversation.

13 years 11 months ago #13378869 by cosma
Replied by cosma on topic Re:jJoystick Interface
<P style="MARGIN: 0px">The analog joystick works fine in position mode if you are using the encoder for feedback.
<P style="MARGIN: 0px">
<P style="MARGIN: 0px">Please use a voltmeter to verify that the joystick gives you the full range at its output: 0V at min, 2.5V at center, 5V at max.

Please Log in or Create an account to join the conversation.

13 years 11 months ago #13398930 by hemantdandekar

The joysticks that i could found are with +/- 10% swing. Could you guide me as where could i find the joystick of the specification as needed by controller.

Please Log in or Create an account to join the conversation.

13 years 11 months ago #13400247 by cosma
Replied by cosma on topic Re:jJoystick Interface

We have no particular model or brand we can recommend. Please see the links to third party products on our web site for links to a few joystick manufacturers we have identified.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.091 seconds