Header on SDC2130

Can the LEDs on the SDC2130 be extended to a front panel (e.g. are there pins for this on the undocumented pin header on the board)?

thanks,
Richard

You can miror the Power LED by connecting an external LED between the 5V and Ground pin on the 15-pin connector.

You can miror the Status LED by connecting a LED on one of the two Digital output pins of the 15 pin connector. Then go in the configuration menu of Roborun and set the selected Digital output as status.

You will not be able to miror the USB led but this one is less useful anyway

OK, I\'ve done this, but I can\'t get the mirror status function to work. The wiring is all correct because I can get my external LED to light up if I select motor on, or motor reverse in the Roborun+ menu (and, obviously, set the motor running in the Run tab).

However, try as I might I can\'t get it to show any sign of life when I tell it to mirror the status LED (which is flashing happily away).

What am I doing wrong?

cheers,
Richard

It appears this function has a bug. We\'ll investigate and fix.

Do you have any update on this bug fix yet?

thanks,

Richard

Any news on fixing this bug? It was not fixed in the last beta version unfortunately.

The problem has been found and fixed. We\'ll release a beta version of the firmware this week.

Firmware is attached. This is beta code. Pls try and report.

I forgot to ask the obvious question: does this beta version include the goto encoder commands of the last beta?

thanks,
Richard

It does.