Brushless Motor control using HBL2350

Hi I am currently using HBL2350 to control 2 motors. Currently I met a few issue which is
1) I could not perform seperate motor control as when i speed up one motor, two motor start running
2) Does the motor controller need to calibrate the brushless motor?

Hope that someone can reply me on this. Thanks

Make sure the controller is not configured in mixed mode. Reset the controller to defaults using the button in the Config tab of the PC utility.

Test your motors using the PC utility.

There is no motor calibration needed

Hi Thanks for the reply. However, when i changed to seperate mode... the motor could not move... it jerk once and stalled..... when i change to mixed mode, both motor can run but when i stop it, it goes over current and the controller E-stop the motor.

Try to first make each motor run while in separate mode. Make sure that you dont have some wires mixed up, i.e have all wire for motor 1 going to motor 1, same for motor 2.

Enable the mixed mode only when motors run smoothly in both directions in separate mode.