Need a controller for Exlar gear motor

15 years 9 months ago #29526642 by Anonymous
Need a controller for Exlar gear motor was created by Anonymous
Do you have a controller that can operate an Exlar GLG-090-010 gear motor, 3 stack 338 motor? Customer has 230 VAC, 3 phase power available.

Please Log in or Create an account to join the conversation.

15 years 9 months ago #29526643 by Roboteq
Replied by Roboteq on topic RE: Need a controller for Exlar gear motor
I could not find this specific motor at the Exlar web site.
In any case we make controllers for permanent magnet DC brushed motors up to 36 Volt DC.
If this motor falls in this category, then we can help you if you let us have a data sheet of the motor. Please contact us at This email address is being protected from spambots. You need JavaScript enabled to view it.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.059 seconds