usb is not recognised

9 years 6 months ago #29528912 by Faisal_engr
when i attached my sdc2130 controller via usb to laptop then i recieve a message that usb is not recognised or malfunctioned .. it was working perfectly before .. i already uninstall my usb drivers and still no luck and also check my cable which is fine. so kindly help me as soon as possible about this issue.

thanks
Faisal Aftab

Please Log in or Create an account to join the conversation.

9 years 6 months ago #29528914 by Griffin Baker
Replied by Griffin Baker on topic usb is not recognised
try going into your device manager and uninstalling the driver while cable is connected to controller while the controller is powered on. Then after it finishes uninstalling, unplug the USB and plug it back in and see if the USB drivers install.

Please Log in or Create an account to join the conversation.

9 years 6 months ago #29528931 by Faisal_engr
Replied by Faisal_engr on topic usb is not recognised
i have done this but it says unknown device and again usb is not recognised message appears.

Please Log in or Create an account to join the conversation.

9 years 6 months ago #29528935 by Faisal_engr
Replied by Faisal_engr on topic usb is not recognised
?

Please Log in or Create an account to join the conversation.

9 years 6 months ago #29528936 by Griffin Baker
Replied by Griffin Baker on topic usb is not recognised
How old is this controller?

There is a small black 6 pin IC neat the USB, are all the pins soldered down to the pads? Also, does the USB pins have their pins also properly soldered to the pads?

Please Log in or Create an account to join the conversation.

9 years 6 months ago #29528947 by Faisal_engr
Replied by Faisal_engr on topic usb is not recognised
its 6 month old

Please Log in or Create an account to join the conversation.

9 years 6 months ago #29528948 by Griffin Baker
Replied by Griffin Baker on topic usb is not recognised
You can connect the controller via serial, pins 2,3,5 (Refer to datasheet page 6).

Please Log in or Create an account to join the conversation.

8 years 10 months ago #29529797 by Goncharenko
Replied by Goncharenko on topic usb is not recognised
I also had the same problem with my netbook Samsung N150 (Win7), but the same controller and the same USB cable worked properly with another my PCs.

Please Log in or Create an account to join the conversation.

8 years 10 months ago #29529798 by TechSupport
Replied by TechSupport on topic usb is not recognised
Did the PC device manager see the controller at all when you supplied power to the controller?

If you connect our controller for the first time via USB, the controller will install USB drivers. For the SDC2150N and SDC2160N, that doesn't happen because the USB driver chip is removed due to interference with the Can Bus function.

When connected via serial make sure your settings for the port are the following as described in the usermanual.

The controller’s serial communication port is set as follows (page 112):
• 115200 bits/s
• 8-bit data
• 1 Start bit
• 1 Stop bit
• No Parity

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.072 seconds