Status LED on SDC 1130

Hey guys

I'm hoping to find out what this Status LED blink code is supposed to mean on my Roboteq SDC 1130

m.youtube.com/watch?v=BMcjp2_lRo4&feature=youtube_gdata_player

Any help is appreciated.

Regards
David

2 blinks means its' in pulse mode.

That's what it should be in, I'm using it as an RC controller for an electric actuator. However, the controller is not responding to RC signal anymore, but it was the last time we used it. Will the configuration of the motor have any bearing on it's working? It does show on the diagram a single motor wired to M1 and M2, but I didn't understand why that's necessary.

Is your pulse radio throttles centered? Also, are both pulse inputs on your transmitter box plugged in? Channel 1, 2, B?

If you 2 pulse inputs assigned in the controller, and only one of the plugs is plugged in, then it will do anything until that pin is plugged in, or you go into the configurations and completely disable the one not used.

I'll check to make sure the trims on the TX are centred (it's done on a Spektrum radio, FYI), and also, it's only ever had 1 RC cable attached to that multi-pin plug, the signal wire and the GND wire, and it has worked in that configuration since it was installed. It's just now we put a new actuator in, it seems to not want to know.