1. Forum
  3. Roboteq Motor Controllers
  5. General Issues
  7. SDC2160NS Single motor config?

SDC2160NS Single motor config?

8 years 6 months ago #29529905 by deadboxx47
SDC2160NS Single motor config? was created by deadboxx47
I have the SDC2160NS controller and I want to run a single motor from it. Can the configuration from the SDC2160S be used?
Attachments:

Please Log in or Create an account to join the conversation.

8 years 6 months ago #29529906 by TechSupport
Replied by TechSupport on topic SDC2160NS Single motor config?
It is already by firmware meant to only drive one motor.

The m1+ and - will need to be bridged together and the M2+ and - will need to be bridged together. then your motor wires will go into motor 1 and 2.
The following user(s) said Thank You: deadboxx47

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. General Issues
  7. SDC2160NS Single motor config?
Time to create page: 0.069 seconds