sdc2150 doesn't respond to microbasic script
8 years 5 months ago - 8 years 5 months ago #29530358
by maha
sdc2150 doesn't respond to microbasic script was created by maha
hello,
i have SDC2150 micro-controller and when i use roborun plus and move the sliders to run a motor. it runs and everything is ok.
and then i ran the motor using a microbasic script. i downloaded the script and the motor worked fine.
after that, i tried running it again exactly the same way using the same microbasic script and the microcontroller never responded.. do u have any clue about this issue?
it seems like the MC is hanged or something.
i tried everything. i reset the MC to defaults.
i disconnected it for a whole day.
nothing so far.
i have SDC2150 micro-controller and when i use roborun plus and move the sliders to run a motor. it runs and everything is ok.
and then i ran the motor using a microbasic script. i downloaded the script and the motor worked fine.
after that, i tried running it again exactly the same way using the same microbasic script and the microcontroller never responded.. do u have any clue about this issue?
it seems like the MC is hanged or something.
i tried everything. i reset the MC to defaults.
i disconnected it for a whole day.
nothing so far.
Please Log in or Create an account to join the conversation.
8 years 5 months ago #29530361
by TechSupport
Replied by TechSupport on topic sdc2150 doesn't respond to microbasic script
There isn't enough information to figure what exactly the problem is.
If you would, please post the script that you are using, or at least provide the settings you used and how the motors are driven; analog, serial, pulse.
If you would, please post the script that you are using, or at least provide the settings you used and how the motors are driven; analog, serial, pulse.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.052 seconds