Renaming of Configuration Parameter
8 years 1 month ago #29530435
by rajeshwar
Renaming of Configuration Parameter was created by rajeshwar
I am using 6 VBL2360 drives for my application. I was not able to put different names for different drive parameters. When I tried to rename configuration parameters like DIN1 as Joint 1 and AIN1 as command 1, the same name appears for all the drives. So Now DIN1 is renamed as Joint 1 in all the drives. What should I do?
Please Log in or Create an account to join the conversation.
8 years 1 month ago #29530439
by TechSupport
Replied by TechSupport on topic Renaming of Configuration Parameter
Which version of Roborun+ are you using? Date code is located at the top middle area of Roborun+.
Please Log in or Create an account to join the conversation.
8 years 1 month ago #29530453
by rajeshwar
Replied by rajeshwar on topic Renaming of Configuration Parameter
The version displayed in the middle area is Rev 1.4 11-27-14.
Please Log in or Create an account to join the conversation.
8 years 1 month ago #29530456
by TechSupport
Replied by TechSupport on topic Renaming of Configuration Parameter
I checked on mine and didn't have the issue that you are seeing. Did you try closing the Roborun and powering down the first controller, then connect the next one in a new instance of Roborun?
Please Log in or Create an account to join the conversation.
8 years 1 month ago #29530469
by rajeshwar
Replied by rajeshwar on topic Renaming of Configuration Parameter
I have single RS-232 Port available and I did not close the running instance of Roborun+. I was powering down the first controller, disconnect the RS-232 cable and then connecting the next drive on same serial port. I shall check it again by closing down the Roborun+ application software.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.059 seconds
