RIOX-1216 -Analog Output

7 years 8 months ago #29531544 by Hasini
Hello

I am planning to write a code to change the Analog OP voltage of the Analog OP ports of the RIOX .What is the command(in microbasic language) to set the analog voltage level in the corresponding analog OP pin?

Please Log in or Create an account to join the conversation.

7 years 8 months ago #29531559 by niko
Replied by niko on topic RIOX-1216 -Analog Output
Hello the command is AO. Follow the datasheet for details about analog outputs. I copy from the datasheet:

Analog Output Connection
The two analog outputs will generate a voltage ranging from 0 to 3300 mV. The output is connected directly to an
operational amplifier with limited current drive capability. It should therefore only be connected to relatively high
impedance loads (1kOhm or higher).

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.051 seconds