Factory Reset A Roboteq after script causes freeze
7 years 3 months ago #29531782
by Dman
Factory Reset A Roboteq after script causes freeze was created by Dman
The script is has some bad command in it that causes the Roboteq to stop communicating over the USB. When the USB is plugged in and the Roboteq setup software is used it will just hang and crash the Roboteq setup software. How can I reset the reboteq back to factory default?
Please Log in or Create an account to join the conversation.
7 years 3 months ago #29531788
by niko
Replied by niko on topic Factory Reset A Roboteq after script causes freeze
Try the following:
- Connect via RS232 (it might work with USB but it is more secure with RS232)
- Set the COM Port to the one that is assigned to controller instead of Auto.
- Go to console tab. There you will see the controller to restart constantly.
- Press repeatedly the stop script button. Eventually the script will stop and the controller will not restart.
- Then disable the script auto start and erase the faulty script from flash.
- Connect via RS232 (it might work with USB but it is more secure with RS232)
- Set the COM Port to the one that is assigned to controller instead of Auto.
- Go to console tab. There you will see the controller to restart constantly.
- Press repeatedly the stop script button. Eventually the script will stop and the controller will not restart.
- Then disable the script auto start and erase the faulty script from flash.
The following user(s) said Thank You: Dman
Please Log in or Create an account to join the conversation.
7 years 3 months ago #29531792
by Dman
Replied by Dman on topic Factory Reset A Roboteq after script causes freeze
Your solution worked good. Thank you
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.059 seconds
