Commands for Sinusoidal Control
- bencornwellmott
- Topic Author
- Offline
Less
More
- Posts: 2
- Thank you received: 0
7 years 5 months ago #29531942
by bencornwellmott
Commands for Sinusoidal Control was created by bencornwellmott
Hello,
I can't seem to find any references on how to set the Sinusoidal commands through a microbasic script.
I'm specifically looking for the following:
1. Angle Zero Adjust
2. Angle Timing Advance
3. Flux Proportional Gain
4. Flux Integral Gain
Also, is there a way to read the FOC flux amps and FOC torque amps using a getvalue command?
I can't seem to find any references on how to set the Sinusoidal commands through a microbasic script.
I'm specifically looking for the following:
1. Angle Zero Adjust
2. Angle Timing Advance
3. Flux Proportional Gain
4. Flux Integral Gain
Also, is there a way to read the FOC flux amps and FOC torque amps using a getvalue command?
Please Log in or Create an account to join the conversation.
7 years 5 months ago #29531957
by blake
Replied by blake on topic Commands for Sinusoidal Control
A new version of our manual will be available very soon with more documentation about sinusoidal commands. In the mean time you should find all you are asking about in the attached doc.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.054 seconds
