Serial Communication with RobotoQ 1360
7 years 2 months ago #29532127
by NPK
Serial Communication with RobotoQ 1360 was created by NPK
Hi
Myself praveen, I am very new to robotoq now I want to make one application to control servo motor using serial communication.
I couldn't able to find any example to execute actions based on my serial command from a remote system.
If there any basic serial command available kindly share the link or file.
Myself praveen, I am very new to robotoq now I want to make one application to control servo motor using serial communication.
I couldn't able to find any example to execute actions based on my serial command from a remote system.
If there any basic serial command available kindly share the link or file.
Please Log in or Create an account to join the conversation.
7 years 2 months ago #29532129
by blake
Replied by blake on topic Serial Communication with RobotoQ 1360
Hello,
All of the configuration and run commands are referenced in our User Manual in Section 16, beginning on Pg 163. If you are just trying to do a simple open loop run command you would use !G, see page 168.
All of the configuration and run commands are referenced in our User Manual in Section 16, beginning on Pg 163. If you are just trying to do a simple open loop run command you would use !G, see page 168.
The following user(s) said Thank You: NPK
Please Log in or Create an account to join the conversation.
7 years 2 months ago #29532130
by NPK
Replied by NPK on topic Serial Communication with RobotoQ 1360
Thanks for the reply,
Is this manual common for all the RoboteQ Controllers.
Is this manual common for all the RoboteQ Controllers.
Please Log in or Create an account to join the conversation.
7 years 2 months ago #29532131
by blake
Replied by blake on topic Serial Communication with RobotoQ 1360
yes it is
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.057 seconds
