1. Forum
  3. Roboteq Motor Controllers
  5. General Issues
  7. RESET command from MicroBasic

RESET command from MicroBasic

6 years 7 months ago #29532194 by jajek
RESET command from MicroBasic was created by jajek
Is serial maintenance command %RESET available from MicroBasic script?
E.g., in CANopen after receiving NMT Reset Node command I would like to stop motor and call %RESET from my script.

Please Log in or Create an account to join the conversation.

6 years 7 months ago #29532195 by blake
Replied by blake on topic RESET command from MicroBasic
No, maintenance commands are not available to be used from a MicroBasic script.

In CANOpen when an NMT command is received (any NMT command) then the CANOpen stack acts by itself according to the command.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. General Issues
  7. RESET command from MicroBasic
Time to create page: 0.054 seconds