dual hall cable

6 years 6 months ago #29532767 by AFewSkroosLoose
dual hall cable was created by AFewSkroosLoose
Hi new to the forum. Just bit the bullet and ordered hbl2360 dual sensored brushless controller. Ill be running (2) 650w 48volt trike motors with white squarish molex sensor connectors, the type used on chinese scooter controllers i believe.

Am i right that i will need to solder sensor wires to dual hall cable i ordered with my controller, or is there another method? Im only going by pic of dual hall cable on this site.

Thanks,
Eli

Please Log in or Create an account to join the conversation.

6 years 6 months ago #29532768 by blake
Replied by blake on topic dual hall cable
Hello Eli,

Yes the dual hall cable will have a small pcb with holes for you to solder your Hall sensor signal wires as well as the +5V and GND wires to power the sensors. This will then plug directly into the motor controller:
The following user(s) said Thank You: AFewSkroosLoose

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.049 seconds