The using problems about magnetic latching relay

3 years 5 months ago #29532818 by ailex1995
Good afternoon~all,I don't know if I put forward my problems,if not,please recommend me suitable one,thank you in advance!
I am considering using magnetic latching relay which the model is http://www.kynix.com/uploadfiles/pdf8827/IM41GR+3VDC.pdfIM41GR , the voltage of coil is 3VDC. Here a NC7WZ17 is used.(The Non-inverting buffer of two channels,33MA,the small volumn ) Now I have two doubts to ask you for help:
1). Please look at the following circuit: are there any hidden dangers?

2). When it’s driven by electric level or pluse (SET), how long can it keep after remove the driven signal? Is it right that if I don’t cancel the driven signal ( RESET) ,the state of SET can always keep in ?

Welcome to have a discussion with me. Your suggestions will be appreciated!
PS: Please forgive me if there any wrong in English grammar ! I’m trying my best to learn English !
Attachments:

Please Log in or Create an account to join the conversation.

3 years 5 months ago #29532823 by blake
Hello

We would not be able to answer any questions about these parts, I would suggest that you contact the manufacturer's support department.

If you have any questions about RoboteQ motor controllers or sensors then we will be happy to answer those.

Thank you

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.215 seconds