How to connect the mgs1600gy band to the sdc2130 motor controller?

5 years 5 months ago #29533551 by Davidetwinp98
HI guys,

There is someone who knows how can i connect the mgs1600gy band to the sdc2130 motor controller ?

Beacause I bought the magnetic band a while ago, but now I realized that the connector of the band and that of the controller have both female exits....Does anyone know how to do?

are there any solution?(in addition to the typical solution to buy an adapter).

Please Log in or Create an account to join the conversation.

5 years 5 months ago #29533563 by Gabriel_Isko
Are you referring to the MGS1600GY magsensor? I'm not sure what you mean by band.

Our recommended method for connecting a Magsensor to one of our controllers is through the Magsensor PWM output. You can connect it to any pulse input on the IO port of our controllers, as well as power the sensor from the IO port VCC and GND. Unfortunately, we do not currently make a cable to do this directly.

Please Log in or Create an account to join the conversation.

5 years 5 months ago #29533567 by Davidetwinp98
Replied by Davidetwinp98 on topic RIOX CARD PROBLEM
Good Mornig, thank you for your support.
i have another question.
I want to connect to your RIOX board , two HC-SR04 Ultrasonic sensor to make an obstacle avoidance machine

How can i do it? what is the connection scheme?

Please Log in or Create an account to join the conversation.

5 years 5 months ago #29533582 by Gabriel_Isko
Replied by Gabriel_Isko on topic RIOX CARD PROBLEM
I responded in your other thread, sorry for the late response.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.057 seconds