- Forum
- Roboteq Motor Controllers
- General Issues
- HOW TO ENABLE AN OUTPUT PORT ON THE RIOX CARD WITH MICROBASIC?
HOW TO ENABLE AN OUTPUT PORT ON THE RIOX CARD WITH MICROBASIC?
- Davidetwinp98
- Topic Author
- Offline
Less
More
- Posts: 59
- Thank you received: 0
5 years 5 months ago #29533611
by Davidetwinp98
I just try to enable an output port with the command " setcommand(_D1, 16)" but nothing happens, why?
are there any solutions?
are there any solutions?
Please Log in or Create an account to join the conversation.
5 years 5 months ago #29533613
by blake
Replied by blake on topic HOW TO ENABLE AN OUTPUT PORT ON THE RIOX CARD WITH MICROBASIC?
Please tell me which version of firmware is currently loaded to your RIOX. This will show in the bottom right corner of the RIOX PC Utility window when the card is connected.
Please Log in or Create an account to join the conversation.
- Davidetwinp98
- Topic Author
- Offline
Less
More
- Posts: 59
- Thank you received: 0
5 years 5 months ago #29533615
by Davidetwinp98
Replied by Davidetwinp98 on topic HOW TO ENABLE AN OUTPUT PORT ON THE RIOX CARD WITH MICROBASIC?
Hy blake ,
Very Thanks for your reply but i just solve the problem , because i had forgot that the riox card must be alimented by 12volt battery , this were the problem that don t allow me to enable any port with success
Very Thanks for your reply but i just solve the problem , because i had forgot that the riox card must be alimented by 12volt battery , this were the problem that don t allow me to enable any port with success
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
- Forum
- Roboteq Motor Controllers
- General Issues
- HOW TO ENABLE AN OUTPUT PORT ON THE RIOX CARD WITH MICROBASIC?
Time to create page: 0.050 seconds