1. Forum
  3. Roboteq Motor Controllers
  5. General Issues
  7. CAN-BUS COMMUNICATION

CAN-BUS COMMUNICATION

4 years 9 months ago #29533771 by Davidetwinp98
CAN-BUS COMMUNICATION was created by Davidetwinp98
is there anyone that know how to commuicate between arduino and riox using can bus protocol?

Please Log in or Create an account to join the conversation.

4 years 9 months ago #29533778 by Gabriel_Isko
Replied by Gabriel_Isko on topic CAN-BUS COMMUNICATION
You will need an external CAN shield to communicate over CAN from an Arduino unfortunately.

Please Log in or Create an account to join the conversation.

4 years 9 months ago #29533782 by ethanscott
Replied by ethanscott on topic CAN-BUS COMMUNICATION
Hey all,
I am new to this forum and new to Arduino programming and I was wondering if you guys could help me out with this issue that I am facing.
I think pin 7 and 8 of my arduino uno is not functioning properly.
Could anyone tell me a troubleshooting technique or is it advisable to just take it to a proper technician?

Please Log in or Create an account to join the conversation.

4 years 9 months ago #29533791 by Gabriel_Isko
Replied by Gabriel_Isko on topic CAN-BUS COMMUNICATION
Hey, you can check it with a multimeter Ethan. I would definitely recommend looking for arduino support on the arduino forum .

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. General Issues
  7. CAN-BUS COMMUNICATION
Time to create page: 0.059 seconds