ROBOCAN WIRING
4 years 8 months ago #29534054
by pamon
ROBOCAN WIRING was created by pamon
I have many problems trying to connect 2 fdc3260 controllers to one mgs1600gy sensor via robocan.
Does robocan need a particular kind of cabling?
fdc3260 are nod 1 and 4, and mgs1600fy is node 2.
They are connected via short jumpers (20ga) 9 inches long
118.5 ohm terminators at both ends.
twisted pair? shielded? witch gage?
Does robocan need a particular kind of cabling?
fdc3260 are nod 1 and 4, and mgs1600fy is node 2.
They are connected via short jumpers (20ga) 9 inches long
118.5 ohm terminators at both ends.
twisted pair? shielded? witch gage?
Please Log in or Create an account to join the conversation.
- Gabriel_Isko
4 years 8 months ago #29534056
by Gabriel_Isko
Replied by Gabriel_Isko on topic ROBOCAN WIRING
Hey this setup should work.
You posted in another thread saying that your setup is working now with new firmware. Can I assume this was the issue?
You posted in another thread saying that your setup is working now with new firmware. Can I assume this was the issue?
Please Log in or Create an account to join the conversation.
4 years 8 months ago #29534059
by pamon
Replied by pamon on topic ROBOCAN WIRING
it worked between two fdc3260, but not with the mgs1600gy.
Also i will need longer run of cables (10ft), so is there any recommendation for wiring?
Also i will need longer run of cables (10ft), so is there any recommendation for wiring?
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.054 seconds
