1. Forum
  3. Roboteq Motor Controllers
  5. General Issues
  7. gyro angol from motor controller

gyro angol from motor controller

4 years 4 months ago #29534299 by Davidetwinp98
gyro angol from motor controller was created by Davidetwinp98
how can i read the angle of gyroscope from the controller?

Because the _ANG command in the motor controller is used to read the rotor angol , but i need to read the gyroscope angle.

Anyone know if there is any command to do this?

Please Log in or Create an account to join the conversation.

4 years 4 months ago #29534300 by Gabriel_Isko
Replied by Gabriel_Isko on topic gyro angol from motor controller
It should be !GY. From the data sheet:
Attachments:

Please Log in or Create an account to join the conversation.

4 years 4 months ago #29534301 by Gabriel_Isko
Replied by Gabriel_Isko on topic gyro angol from motor controller
Acuatlly, ANG should still work with the MGS1600GY, and give the double integrated value of the GY command.

Please Log in or Create an account to join the conversation.

3 years 10 months ago #29534665 by deepakjayaraj
Replied by deepakjayaraj on topic gyro angle from motor controller
I am also running into trouble with the ANG command. I have connected the MGS1600GY to the FBL2360 and I am trying to use the angle value to make the device go in a straight line. getValue(_ANG) is not returning any value on my script. Please let me know if there is a good way to troubleshoot this?

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. General Issues
  7. gyro angol from motor controller
Time to create page: 0.070 seconds