SBL2360 isn´t reading hall sensors

Hello

I'm working with a SBL2360 connected to two brushless motors from "Oriental Motor" model: BLHM5100K-GFS (catalog.orientalmotor.com/item/gearheads...heads/blhm5100kc-gfs).

I tested the motors with the SBL2360 controller and the original Oriental Motor controller (catalog.orientalmotor.com/item/all-categ...controllers/blhd100k).
Also I test them in a Chinese driver and it's also working, but when I run them into the RoboteQ driver they don't respond in a trapezoidal or sinusoidal mode.

I check the hall sensors connected to the Oriental Motors driver with oscilloscope and they looks well pulsing, but when the sensors are connected in the SBL2360 they don't respond and only stay in low level.

Is it something about the inputs of the hall sensor in the driver?

Solved!

Glad you solved it, what ended up being the problem? We see a lot of issues with the hall labeling on oriental motors, so any insight into them would be appreciated.

It was all about the connection, I took reference with a Chinese controller so the cable colors were wrong. I got the original Oriental motor driver and took reference.

Sounds good, we have had a few problems with the labeling on oriental motors. You can also always change the order of the hall sensor order by modifying the Hall Sensor Map setting in the configuration tab of Roborun+.