RoboCAN issue

4 years 9 months ago #29534364 by aarontan
RoboCAN issue was created by aarontan
Hello,

I have 4 SDC2130 linked together for a robot that I am building. The first axle SDC2130 is controlled by the laptop over USB where as the remaining 3 are controlled via RoboCAN.

I noticed that the fourth axle SDC2130 flashes a different led pattern than axle 1-3. I also notice that the motors of this controller lags behind the other in terms of response as well. For example, I have 4 motors controllers with 2 motors controlled by each. If I send a command to stop all 4 sdc2130 (8 motors). 7 motors will stop except 1 which takes a second longer to stop. The other motor controlled by the same 4th axle controller reacts at the same time as the others.

Please see video: www.youtube.com/watch?v=-oMOO4f1GCY&feature=youtu.be

I am wondering, what is the meaning of this red light? does it have something to do with the lag in response?

Thanks

Please Log in or Create an account to join the conversation.

4 years 9 months ago #29534370 by Davidetwinp98
Replied by Davidetwinp98 on topic RoboCAN issue
Try to RESET DEFAULT the controller ,from the video i see that the last controller the last led flashes red, so the reset could solve many problems.
Looking the datasheet, i see that there are problems with the communication and the status.

Please Log in or Create an account to join the conversation.

4 years 9 months ago #29534371 by Davidetwinp98
Replied by Davidetwinp98 on topic RoboCAN issue
if you want then you could send me your email, I would like to ask you some information about a slam project that I saw on your channel, and since I'm trying to design and operate a robot that I drive autonomously, I need help

Please Log in or Create an account to join the conversation.

4 years 9 months ago #29534389 by Gabriel_Isko
Replied by Gabriel_Isko on topic RoboCAN issue
You can always email This email address is being protected from spambots. You need JavaScript enabled to view it..

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.060 seconds