MAGSENSOR GYROSCOPE
- Davidetwinp98
- Topic Author
- Offline
Less
More
- Posts: 59
- Thank you received: 0
4 years 8 months ago #29534477
by Davidetwinp98
MAGSENSOR GYROSCOPE was created by Davidetwinp98
what is the command to read the Z axis from the controller ?
beacuse in the new software of magsensor (TRACK SENSOR) i can see the gyroscope , but how can i read these number from the controller ?
beacuse in the new software of magsensor (TRACK SENSOR) i can see the gyroscope , but how can i read these number from the controller ?
Please Log in or Create an account to join the conversation.
- Gabriel_Isko
4 years 8 months ago #29534486
by Gabriel_Isko
Replied by Gabriel_Isko on topic MAGSENSOR GYROSCOPE
Hey Davide, Let us know how you connect to the magsensor. You may have to send it over RS232 or CAN.
Please Log in or Create an account to join the conversation.
- Davidetwinp98
- Topic Author
- Offline
Less
More
- Posts: 59
- Thank you received: 0
4 years 8 months ago #29534494
by Davidetwinp98
Replied by Davidetwinp98 on topic MAGSENSOR GYROSCOPE
Hi Isko ,
I'm connected to the controller via MultiPWM
I'm connected to the controller via MultiPWM
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.059 seconds