Fault detection on SSI encoders

4 years 8 months ago #29534513 by gerry.boast@btinternet.co
Is there any fault detection for SSI encoders ? If the encoder is disconnected I would like to see a flag appear so that I can take necessary action. Does this exist as standard ? At the moment, if I pull out the encoder the controller continues to pump current into the motor, obviously not commutating.
Using an FBL2360.

Please Log in or Create an account to join the conversation.

4 years 7 months ago #29534521 by Gabriel_Isko
Replied by Gabriel_Isko on topic Fault detection on SSI encoders
Nope. There is no hardware to detect that it is disconnected.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.051 seconds