SDC2130S Firmware upgrade Issue-No Response Yet?

***UPDATE***  if this is not reversable? Is there a way to reset this back to factory and start over?!


Hi Everyone
I recently upgraded firmware on a SDC2130S controller along with RoboPlus software.  Now, RoboPlus reports its controller findings as a SDC2160S? Of course this is automated, I can choose the correct model in "Offline" mode, but it goes back to the 2160S when sync'd to controller?

The firmware I updated to was v2.01 (SDC21XXS) and I also tried v2.1 but with the same result on  reading an incorrect model.

Any ideas?

Thanks in Advance..
Brian