1. Forum
  3. Roboteq Motor Controllers
  5. MicroBasic
  7. Access to spectrum data

Access to spectrum data

11 years 5 months ago #29526217 by Michael Burton
Replied by Michael Burton on topic Re:Access to spectrum data
As far as I know I have the latest Roborun+ I got it from the download software yesterday.

Please Log in or Create an account to join the conversation.

11 years 5 months ago #29526219 by Michael Burton
Replied by Michael Burton on topic Re:Access to spectrum data
I believe that I have the latest software.

What is the revision and date.

I have 8/24/11 of 1.2

Please Log in or Create an account to join the conversation.

11 years 5 months ago #29526221 by Michael Burton
Replied by Michael Burton on topic Re:Access to spectrum data
that is 08/03/11 of roborun and 8/24/11 on the firmware.
I see that there is a new firmware available. Should I upgrade?

Please Log in or Create an account to join the conversation.

11 years 4 months ago #29526237 by Michael Burton
Replied by Michael Burton on topic Re:Access to spectrum data
I have tried to bind the spectrum using the method you describe. Unfortunately it causes the SDC2130 to loose communication with the computer. I have been unable to bind using this method.

In addition I see now way to inhibit the motors from moving when the Spectrum radio is enabled and now way to read the data if the spectrum radio is disabled.

Please Log in or Create an account to join the conversation.

11 years 4 months ago #29526239 by roboteq
Replied by roboteq on topic Re:Access to spectrum data
YOu can prevent the motors to respond to the spektrum radio by going in Command Priorities and changing the Spektrun to None in the config menu

It is strange that the controller would quit.

Does it crash when after you send the %bind command or when you plug the receiver?

Please Log in or Create an account to join the conversation.

11 years 4 months ago #29526241 by Michael Burton
Replied by Michael Burton on topic Re:Access to spectrum data
When I plug in the receiver.

Please Log in or Create an account to join the conversation.

11 years 4 months ago #29526243 by Michael Burton
Replied by Michael Burton on topic Re:Access to spectrum data
Ok I got it to pair.

My next question is how to get the spectrum radio data without making the motors active.

Ir I set a channel then it moves the motor with that channel. If I don\'t set a channel I can not read any data.

Please Log in or Create an account to join the conversation.

11 years 4 months ago #29526245 by Michael Burton
Replied by Michael Burton on topic Re:Access to spectrum data
I assigned both motors to ch 6 and then Nothing moves and I can still read the numbers.

Is there a flag or something that can tell me when the spectrum radio is on?

Please Log in or Create an account to join the conversation.

11 years 4 months ago #29526247 by roboteq
Replied by roboteq on topic Re:Access to spectrum data
Enable the radio in the spektrum menu but remove it from the command priority list

Please Log in or Create an account to join the conversation.

11 years 4 months ago #29526249 by Michael Burton
Replied by Michael Burton on topic Re:Access to spectrum data
Ok and how do I know when the spectrum radio is on?

Please Log in or Create an account to join the conversation.

  1. Forum
  3. Roboteq Motor Controllers
  5. MicroBasic
  7. Access to spectrum data
Time to create page: 0.119 seconds