Serial Output for LCD
- iphillipsca
- Topic Author
- Offline
Less
More
- Posts: 9
- Thank you received: 0
8 years 3 months ago #29530875
by iphillipsca
Serial Output for LCD was created by iphillipsca
Hello,
I was hoping to use an "off the shelf" serial display for amps/volts or what ever else(see PDF). But, the display is defaulted at 9600. It can be changed but it needs to talk at that level before it can be changed.
Does anyone know if the serial output can be altered to a different baud for this application?
I've looked on the forum and so far, it doesn't look like it.
Any ideas appreciated.
Thanks.
I was hoping to use an "off the shelf" serial display for amps/volts or what ever else(see PDF). But, the display is defaulted at 9600. It can be changed but it needs to talk at that level before it can be changed.
Does anyone know if the serial output can be altered to a different baud for this application?
I've looked on the forum and so far, it doesn't look like it.
Any ideas appreciated.
Thanks.
Please Log in or Create an account to join the conversation.
8 years 3 months ago #29530877
by TechSupport
Replied by TechSupport on topic Serial Output for LCD
Our controllers use 115200 baud rate. This can be changed over only if 2 conditions are met. Understandably, you will no longer be able to communicate to Roborun+ via serial upon changing this. Your controller must also have a USB port.
If this is the route you wish to go, please contact us via This email address is being protected from spambots. You need JavaScript enabled to view it.
If this is the route you wish to go, please contact us via This email address is being protected from spambots. You need JavaScript enabled to view it.
Please Log in or Create an account to join the conversation.
Time to create page: 0.055 seconds