MGS1600 ZERO CALIBRATION LEVEL FROM SCRIPT
6 years 3 months ago #29532675
by cory944
MGS1600 ZERO CALIBRATION LEVEL FROM SCRIPT was created by cory944
Dear Roboteq Technical Support,
I was wondering if there is a way to calibrate zero level from script for MGS1600.
I know I can send serial command '%zero' but can I do it from script?
Thanks in advance,
Victor.
I was wondering if there is a way to calibrate zero level from script for MGS1600.
I know I can send serial command '%zero' but can I do it from script?
Thanks in advance,
Victor.
Please Log in or Create an account to join the conversation.
6 years 3 months ago #29532676
by blake
Replied by blake on topic MGS1600 ZERO CALIBRATION LEVEL FROM SCRIPT
This is a Maintenance command so no it cannot be done from a MicroBasic script. It must be done either from a serial command or when connected to the MagSensor Utility
The following user(s) said Thank You: cory944
Please Log in or Create an account to join the conversation.
6 years 3 months ago #29532678
by cory944
Replied by cory944 on topic MGS1600 ZERO CALIBRATION LEVEL FROM SCRIPT
Thanks Blake!
Regards,
Victor.
Regards,
Victor.
Please Log in or Create an account to join the conversation.
Time to create page: 0.056 seconds
