1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. AX500 pinout

AX500 pinout

16 years 1 week ago #20455161 by pottillo
AX500 pinout was created by pottillo
Last question, i promise :D

Can you please post the pinout layout and description of the ax500 board? I read on the manual some parameteres are configurable with jumpers but i can't find the righ ones.
Jumpers on the board are marked as J1, J3, j4 and j5 (j2 is used for encoder, right?)

Thank you

Please Log in or Create an account to join the conversation.

16 years 1 week ago #20455639 by cosma
Replied by cosma on topic Re:AX500 pinout
Actually, the only parameter that is configurable with Jumpers is the Single Channel mode.

The headers on the board are mostly for programming the MCU and CPLD at production time.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. AX500 pinout
Time to create page: 0.053 seconds