1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. RS232: Estop & Deadman

RS232: Estop & Deadman

15 years 6 months ago #22333398 by roboteq
RS232: Estop & Deadman was created by roboteq
I've got the AX2550.
I'm confused about the DB15 to DB9 wiring in RS232 mode.

On the DB15, Deadman is on pins 4 & 8, and Estop is on pin 15; so which are the corresponding pins on the DB9? Or are these functions transmitted through the data line?


Please Log in or Create an account to join the conversation.

15 years 6 months ago #22333882 by cosma
Replied by cosma on topic Re:RS232: Estop & Deadman
The supplied DB9 to DB15 cable only connects the RS232 pins: TxData, RxData and Ground. The wiring diagram can be found in the manual.

To use the other signal on the controller's 15pin connector, you need to make your own cable.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
  1. Forum
  3. Roboteq Motor Controllers
  5. Controller Configuration & Operation
  7. RS232: Estop & Deadman
Time to create page: 0.070 seconds