Serial and RC Mode.
- bozooka
- Topic Author
15 years 2 months ago #27463225
by bozooka
Is it possible to use the rs232 (serial mode) and the RC radio control at the same time? I want to use the Roborun program while I am in radio control mode.. For monitoring purposes..
Serial and RC Mode. was created by bozooka
Is it possible to use the rs232 (serial mode) and the RC radio control at the same time? I want to use the Roborun program while I am in radio control mode.. For monitoring purposes..
Please Log in or Create an account to join the conversation.
- cosma
15 years 2 months ago #27485193
by cosma
When in RC mode, the controller will send continuous data string containing most operating parameters (power, amps, voltages ...). The manual shows you how to connect the controller's Tx data while it is receving commands via RC.
Replied by cosma on topic Re:Serial and RC Mode.
When in RC mode, the controller will send continuous data string containing most operating parameters (power, amps, voltages ...). The manual shows you how to connect the controller's Tx data while it is receving commands via RC.
Please Log in or Create an account to join the conversation.
- bozooka
- Topic Author
15 years 2 months ago #27502910
by bozooka
Thanks Cosma I read the part about connecting But it did not say anything about using <FONT color=#ff0066><U>roborun</U></FONT> for monitoring the data..?
Replied by bozooka on topic Re:Serial and RC Mode.
Thanks Cosma I read the part about connecting But it did not say anything about using <FONT color=#ff0066><U>roborun</U></FONT> for monitoring the data..?
Please Log in or Create an account to join the conversation.
- cosma
15 years 2 months ago #27510279
by cosma
If you launch Roborun, go to the Run tab and click on Run, the utility will pick up the data sent by the controller and display it in the boxes and charts.
Replied by cosma on topic Re:Serial and RC Mode.
If you launch Roborun, go to the Run tab and click on Run, the utility will pick up the data sent by the controller and display it in the boxes and charts.
Please Log in or Create an account to join the conversation.
Moderators: tonysantoni
Time to create page: 0.057 seconds