RC Control issue with AX2550

11 years 10 months ago #29408496 by DtotheJ
RC Control issue with AX2550 was created by DtotheJ
I'm using an AX2550 to differential drive a wheelbot. Everything should be wired right because it performs perfectly when hooked up to the Robo-run software.

The problem I'm having is when hooked to the RC receiver, it doesn't respond well, and will "take off" and do random things on its own :0

The RC gear is a JR Racing XR3i. I'm a bit of a newb at all of this, so it might be something simple.

Note: The first time I wired it all up (real sloppy) it seemed to respond pretty decent. Then I made the wiring pretty, and it has a mind of its own.

Note2: The RC radio will operate the servo's that came with it as expected, and without a problem.


Any help would be GREAT!! Thanks.

-Dave

Please Log in or Create an account to join the conversation.

11 years 10 months ago #29431762 by cosma
Replied by cosma on topic Re:RC Control issue with AX2550

This sounds like a case of the radio outputing a noisy signal. Try working on the wiring, radio position, antena position to see if the problem is reduced or eliminated.

Please Log in or Create an account to join the conversation.

Moderators: tonysantoni
Time to create page: 0.156 seconds